Cisco 2509の出品になります。
Octral Cableを使用して、コンソールサーバとして使用する事が多いようです。自宅ラックにマウントしていましたが、年末整理でラックを処分したいため、出品することになりました。
出品にあたりブートのみ確認しております。その他未確認のためNC/NRでお願いします。
-----------------------------------------------------
System Bootstrap, Version 11.0(10c), SOFTWARE
Copyright (c) 1986-1996 by cisco Systems
2500 processor with 2048 Kbytes of main memory
Notice: NVRAM invalid, possibly due to write erase.
F3: 4950920+67220+339876 at 0x3000060
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-I-L), Version 11.3(11a), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 20-Sep-99 07:03 by jjgreen
Image text-base: 0x030298E8, data-base: 0x00001000
cisco 2509 (68030) processor (revision M) with 2048K/2048K bytes of memory.
Processor board ID 07882775, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
8 terminal line(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface IP-Address OK? Method Status Protocol
Ethernet0 unassigned NO unset up down
Serial0 unassigned NO unset down down
Serial1 unassigned NO unset down down
Configuring global parameters:
Enter host name [Router] |
|
